SIZE RANGE: 1/2 through 30 inch.

MATERIAL: Carbon steel.*

FINISH: Black or galvanized; furnished black unless otherwise ordered.

SERVICE: Recommended for the suspension of noninsulated stationary pipe lines.

MAXIMUM TEMPERATURE: 650*F.

APPROVALS: Underwriters' Laboratories listed and Factory Mutual approved for 3/4 through 8 inch pipe. Complies with Federal Specification WW-H-171E (Type 1) and Manufacturers Standardization Society SP-69 (Type 1).

INSTALLATION: Hanger load nut above clevis must be tightened securely to assure proper hanger performance.

ADJUSTMENT: Vertical adjustment without removing pipe may be made from 11/8 to 5 inches, varying with the size of Cleves. Tighten upper nut after adjustment.

- Design has yoke on outside of lower U-strap so yoke cannot slide toward center of bolt, thus bending of bolt is minimized.

• Sizes 5-inch and up have rod and two nuts instead of bolt and nut; thread length on clevis rod is such that the thread locks the nuts in place, and threads are not in shear plane.

ORDERING: Specify pipe size, figure number, name.